Hey guys, before I start putting this together I have a question. I’m putting two nodes on one PC. One node is the usual repeater. The other is a FT897 type remote base. I really like using the parport for cos/keying. And I want to use the same PC’s port for both radios. As long as I keep the ppx=?? stuff within a particular radios node stanza will it work? Or if I have a ptt specified for one radio do I not have the ability to have another ppx=ppp under the “other node” even if (obviously) different pins for each. Like this: [general] [usb2428] hdwtype=0 rxboost=0 txboost=1 carrierfrom=ppinvert ctcssfrom=no txmixa=voice txmixb=no invertptt=0 duplex=0 rxondelay=12 eeprom=0 pp10=cor pp4=ptt [usb28599] hdwtype=0 rxboost=0 txboost=0 carrierfrom=ppinvert ctcssfrom=no txmixa=voice txmixb=voico invertptt=0 duplex=0 rxondelay=0 eeprom=0 pp2=ptt pp11=cor So before I go build this up I’m curious about this point. If it won’t fly I’ll add another PC for remote base controller. I have a few D945GCLF boards. I’d move the remote base to one using Limey George J Csahanin W2DB Cedar Park, TX 512-401-2630 home 401-338-0568 cel