Pete, To turn off the connect/disconnect messages except yours put these commandsin your node parameters in rpt.conf - holdofftelem=1 telemdefault=2 Check to see if either are already there or set differently. You also have full control over courtesy tones and timers in rpt.conf. Look for the linkunkeyct= , unlinkedct=, and hangtime= for linked and unlinked courtesy tones and TX hangtime. Don't be afraid to experiment. Just save the old setting as a comment. You will have to do a 'rpt reload' in the client or restart asterisk to see the results of any changes. 73 Doug WA3DSP http://www.crompton.com/hamradio From: petem001@hotmail.com To: app_rpt-users@ohnosec.org Date: Thu, 29 May 2014 12:59:35 -0400 Subject: [App_rpt-users] Simplex link to a DR-1 Hi guys. Got part of the Yaesu beta testing of there fusion system repeater. So I took there repeater and unconnected my old MSR-2000. The linking to the DR-1 seem a bit problematic, especialy if used in both digital and analog mode (auto switch). So I was thinking of using a small IC-F121S locally on a dummy load at the repeater site to act as the link on the analog side of the repeater, the IC-F121S will handle all the ctcss encoding/decoding. My problem is how should I program my node so that I wont have a tail nor any courtesy tone. But I want voice ID to work. I know that there are 2 duplex setting. one in the rpt.conf file the other is in usbradio.conf. Anyone can help me figure out what i need to do? one other thing, how can I stopp any message from connect/disconnect to my node aside the one initiated from my node. (already did it on the echolink side.) but want to do it on the allstar side.) Thanks for the help.. Pierre VE2PF _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.