Cory I think there is a setting for this propagate_dtmf= see http://209.159.155.200/drupal/node/134 but, for controlling remote asterisk nodes from another asterisk node, you are supposed to use this: see http://209.159.155.200/drupal/node/21 *4node Enter command mode on a remote node *4node Enter command mode on a remote node *4node Enter command mode on a remote node Command mode means send all received DTMF digits to the node number specified (bypassing the local command decoder). Send # to exit command mode, and restore local command decoding. I have had mixed results with it GL Ken KE2N -----Original Message----- From: Corey Dean N3FE <n3fe@repeater.net> To: Jim Duuuude <telesistant@hotmail.com>; app_rpt mailing list <app_rpt-users@ohnosec.org> Sent: Sat, Jan 22, 2011 9:09 am Subject: [App_rpt-users] DTMF Allow Is it possible to get a feature added the will allow DTMF to pass through? I know you can regenerate using the cops but it would be nice to be able to press a sequence and then anything that followed would not mute the touch tones. This would help if asterisk was used as a hub and the other repeaters linking in were using standard controllers. That way one repeater on one end could control one on the other end. Just a thought... I know as of recent this would have been very helpful!!! Corey N3FE _______________________________________________ pp_rpt-users mailing list pp_rpt-users@ohnosec.org ttp://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users