Hello All, I am wanting to configure my node to have two PL tones where when one is used for local communications and the other goes out the link. I know some people were able to get it working and I was wondering if I can get some help. I remember that I could add the other PL tones separated by a comma. From what I understood, the first PL will send the audio out the link and the remaining PLs will be local. My Config: --running DIAL on a small form factor pc. ----using USBRadio ----DSP carrier and PL decode --Repeater is a Kenwood TKR-850 and configured with an open squelch to AllStar, no PL decode or encode. In my usbradio.conf txctcssdefault=100.0 rxctcssfreqs=100.0,88.5 txctcssfreqs=100.0,88.5 When I key up on either PL, the audio goes out the link. Can anyone verify this? Are there any other config changes that need to be made? Thanks Sincerely, boB - W5EVH