Two servers? Are they on different ports and did you set up the ports for each on the Allstar portal? -- Tim :wq On May 28, 2012, at 10:59 PM, Bob Roszkowski wrote:

Tim,

To answer your question, yes. I have the rpt.conf file with the following in the [nodes] stanza:

27161 = radio@127.0.0.1/27161,NONE 28054 = radio@127.0.0.1/28054,NONE 28071 = radio@127.0.0.1/28071,NONE

I have another server sitting here that I am trying to use as a standard. This server I can connect to the other nodes on the same server. I can even connect to all three nodes on the other server with the problem.

I know I am missing something simple. Just don't know where. I don't think it is a NAT issue. But I could be wrong.

boB

On Tue, May 29, 2012 at 12:14 AM, Tim Sawyer <tim.sawyer@me.com> wrote: Are you behind a NAT router?

-- Tim :wq

On May 28, 2012, at 9:55 PM, Bob Roszkowski wrote:

...

I currently have a server with a node setup as a Hub (28054). I tried to add a couple more node numbers to the server for future RTCM boxes. The new node numbers are setup with a HUB (no radio) node type / no radio interface. I am having a problem. If I try to connect the added node numbers to the hub node, it fails. If I connect to any other node outside this server, it connects fine. I have made all the possible changes to the config files. I even went as far as using the online system to create new config files. Both have the same result. Been racking my brain out on this one for a couple days. I just get a 'rpt/connection_failed' .

thanx

boB - W5EVH