Thats the info I have!.. but cant find the physical place on the board!.... Unless I dont look at the good board.. ;-) --- Message initial --- De : "Bryan D. Boyle" <bdboyle@bdboyle.com> Envoyé : 2 juin 2013 17:01 A : "pete M" <petem001@hotmail.com> Cc: App_rpt-users@ohnosec.org Objet : Re: [App_rpt-users] Need connection for msf5000. from my notes: all on control board. tp3: discriminator rx tp4: tx in tp9: ptt active low ag: ground there's extensive docs on repeater-builder.com, free for the asking, that goes into EVERYTHING you may need to know about interfacing to the 5k. -- Bryan Sent from my iPhone 5...small keyboard, big fingers...please forgive misspellings... On Jun 2, 2013, at 16:36, pete M <petem001@hotmail.com> wrote:
Been looking all over the place for a good info on how to interface my msf5000 to my URI.
Got some stuff that point to some test point, but I just cant find them on the digital control board.
Anyone have a photo or a service manual the point where are the test point on the controler so that I can find them? Getting pretty frustrated here...
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
On 6/2/2013 6:13 PM, pete M wrote:
Thats the info I have!.. but cant find the physical place on the board!....
Unless I dont look at the good board.. ;-)
That may well be the case. Look for silver pins sticking up from the board. FWIW, they're .062", and you can use female molex connector sockets to mate to them. Work just fine. The markings are silkscreened onto the board...you just have to be patient; they are there. B
participants (2)
-
Bryan D. Boyle -
pete M