I am brand new to this and have been reading to see if I can find a solution to the problem I am having. I purchased a URI and installed it with no problems. I set up the computer using acid and it accepted the node and server info and seems to come on line fine. When I connect using allstar it connects to the radio and announces it I am connected. When I use the computer microphone I can hear it come out on the radio fine. BUT when I go to listen there is no audio coming back over the link from the radio. I checked with a scope to be sure I had audio and I do. I ran the radio adjustments for rxnoise and rx voice and it said everything was successful. It did have me adjust the squelch higher though. I made sure to open the 2 ports ssh and the udp so I don’t think it is a port issue on the router. I am sure it is something simple but I am not sure where to look next. Any helpful suggestions for a beginner would be appreciated. Thanks Steve