I am trying to setup a new node on a 64bit PC Most of the DTMF tones will not decode while running Asterisk -r I was able to get to a point where all except DTMF 3 would decode does not seem to work now only 5, 6, 0, *, # seem to work I have tweaked the rx settings and a few others, this just does not add up. If I dial in via phone allstar telephone portal it decodes with 0 issues. Everything was working with the same repeater/controller/URI/radio with a similar config on a 32bit computer, I can't imagine that should make any difference but I am slo running 3 nodes (1) URI for now... I have changed the rxmixerset from 6 to 900 and 800 , 700 etc Other diff is I used simpleusb-tune-menu on the 32bit computer but on the 64 I get the error "Error parsing device parameters" so I used the std radio-tune-menu. Anyone have ideas? Attached are conf files...