If you are wanting to quiet the connect and disconnect messages on you node, then put these 2 lines in you rpt.conf file: holdofftelem=1 ; polite telemetry - waits until the channel is not busy to send telemetry locally telemdefault=2 ; timed local telemetry - announces connect/ disconnect messages after a local is executed then turns off all voice announcements after 5 minutes. The telemdefault=2 command allows local announcements after a local command is executed. After a while with no activity locally the announcements wont come on. If you issue a connect then it announces locally on you node. But after a 5 minutes or so the announcements will quiet down and stay off unless you issuue a command locally again and that turns the announcements back on for 5 min. This works great when you are on a linked system system where nodes are constantly connecting and disconnecting. Hope this is what you are looking for. Jon VA3RQ On 9/28/2013 12:14 PM, keith wrote:

Evening all,

It's been a long time since I am sure I did this on my first node build. In the morning I connect to the Winsystem and my node then gets then connects and disconnects while this net is on. I would prefer to only get the first point that my node connect to and then disconnects from and have no other node reports in-between the actual net. I have removed the Echo link connection broadcasts to reduce but would like to reduce the All-Star connection broadcasts please.

Whomever helps thanks

Kind Regards

Keith Handscombe

154e886

_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users