Re: [App_rpt] This might help you help me figure out what is goin' on...
First off, The EEPROM notices can be safely ignored. With a modified USB fob, there is no EEPROM facility. All level settings are stored in a file. The correct command is "radio tune rxnoise". There is no "radio tune" command. You should have an AC noise waveform at the tap on the voltage divider during the "radio tune rxnoise" test Preferably, you should check it with a scope and see what the level is. Levels less than 50 millivolts peak to peak at the tap could be your problem. Roger F. Jordan Sr. wrote:
Hi everyone.
I am getting an error in the cli as follows.
[Feb 15 16:41:36] NOTICE [10592]: chan_usbradio.c:1079 hidthread UNSUCCESSFUL: EEPROM checksum BAD OR No EEPROM installed on channel usb
[Feb 15 16:41:36] NOTICE [10593]: chan_usbradio.c:1079 hidthread UNSUCCESSFUL: EEPROM checksum BAD OR No EEPROM installed on channel usb1
Still unable to get anything to adjust with the radio tune command.
Does the above line look familiar to anyone
Best Regards,
Roger W4RFJ
------------------------------------------------------------------------
_______________________________________________ App_rpt mailing list App_rpt@lists.illiana.net http://lists.illiana.net/mailman/listinfo/app_rpt
Hi Steve, Thanks for the quick reply! Steve W9SH has been on the phone with me and has pretty much put me on the right track! We (actually He) has determined that One of my radios is not configured correctly (I am in the process of fixing! And also we have pretty much gone thru all the files to ensure that I did not mess anything else up! The "radio tune" command does give you information... according to the docs... it will tell you what usb device is active and info about that device! I appreciate the reply! Roger W4RFJ -----Original Message----- From: app_rpt-bounces@lists.illiana.net [mailto:app_rpt-bounces@lists.illiana.net] On Behalf Of Stephen Rodgers Sent: Friday, February 15, 2008 9:08 PM To: Asterisk Repeater Controler Subject: Re: [App_rpt] This might help you help me figure out what is goin' on... First off, The EEPROM notices can be safely ignored. With a modified USB fob, there is no EEPROM facility. All level settings are stored in a file. The correct command is "radio tune rxnoise". There is no "radio tune" command. You should have an AC noise waveform at the tap on the voltage divider during the "radio tune rxnoise" test Preferably, you should check it with a scope and see what the level is. Levels less than 50 millivolts peak to peak at the tap could be your problem. Roger F. Jordan Sr. wrote:
Hi everyone.
I am getting an error in the cli as follows.
[Feb 15 16:41:36] NOTICE [10592]: chan_usbradio.c:1079 hidthread UNSUCCESSFUL: EEPROM checksum BAD OR No EEPROM installed on channel usb
[Feb 15 16:41:36] NOTICE [10593]: chan_usbradio.c:1079 hidthread UNSUCCESSFUL: EEPROM checksum BAD OR No EEPROM installed on channel usb1
Still unable to get anything to adjust with the radio tune command.
Does the above line look familiar to anyone
Best Regards,
Roger W4RFJ
------------------------------------------------------------------------
_______________________________________________ App_rpt mailing list App_rpt@lists.illiana.net http://lists.illiana.net/mailman/listinfo/app_rpt
_______________________________________________ App_rpt mailing list App_rpt@lists.illiana.net http://lists.illiana.net/mailman/listinfo/app_rpt
participants (2)
-
Roger F. Jordan Sr. -
Stephen Rodgers