In my opinion the best was to set it up is holdofftelem=1 telemdefault=2 This is the default on the BBB and RPi2. What this says is don't send telemetry over top of voice and only send telemetry you initiate and then mute all other telemetry after about 30 seconds. So if you or anyone at your node does a connect or disconnect you will hear it but you will not hear telemetry messages from other nodes after the mute time. 73 Doug WA3DSP http://www.crompton.com/hamradio

From: kk6ecm@gmail.com To: app_rpt-users@ohnosec.org Date: Sun, 16 Aug 2015 10:05:58 -0700 Subject: [App_rpt-users] Silencing connected node connection announcements

I've been searching, and have not discovered how to silence connection announcements from a node which I'm connected ("node xxxx disconnected from node xxxx"). A more general question. Where can I find a data dictionary for the terms in the rpt.conf telemetry stanza?

thanks, Bob kk6ecm

_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.