How to kill all incoming connections
What command can I use to kill all remote incoming connections including echolink.... we had a tornado up jere and using the repeater during that for storm watch was hard as echolink users kept connecting and disconnecting
In rpt.conf you can add something like this example to your [functionsXXXXX] and then use these to disable or enable incoming connection. 949=cop,49 ; Disable incoming connections (control state noice) 950=cop,50 ; Enable incoming connections (control state noicd) Chuck On Thu, Nov 21, 2013 at 6:54 PM, Bradley Haney <hammin75@gmail.com> wrote:
What command can I use to kill all remote incoming connections including echolink.... we had a tornado up jere and using the repeater during that for storm watch was hard as echolink users kept connecting and disconnecting
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
Put another Allstar node on your computer and tie echolink to it rather than your repeater node. Then you can connect or disconnect echolink from your repeater node at will. -- Tim :wq On Nov 21, 2013, at 5:57 PM, Chuck Henderson <rpt2@chuck.midlandsnetworking.com> wrote:
In rpt.conf you can add something like this example to your [functionsXXXXX] and then use these to disable or enable incoming connection.
949=cop,49 ; Disable incoming connections (control state noice) 950=cop,50 ; Enable incoming connections (control state noicd)
Chuck
On Thu, Nov 21, 2013 at 6:54 PM, Bradley Haney <hammin75@gmail.com> wrote: What command can I use to kill all remote incoming connections including echolink.... we had a tornado up jere and using the repeater during that for storm watch was hard as echolink users kept connecting and disconnecting
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
On 11/21/2013 08:35 PM, Tim Sawyer wrote:
Put another Allstar node on your computer and tie echolink to it rather than your repeater node. Then you can connect or disconnect echolink from your repeater node at will.
That's what I've done. 29656 is configured for echolink only. I connect it to 29655, until someone pulls some sort of 'stupid human trick' and macros are set for connect and disconnect. *71 is always a good 'master' disconnect 73 = Best Regards, -Geoff/W5OMR
participants (4)
-
Bradley Haney -
Chuck Henderson -
Geoff -
Tim Sawyer