No Carrier Squelch Mode
I am attempting to get carrier squelch mode to work. The relevant parts of my usbradio.conf are shown below. Even with this configuration the repeater is always in P/L decode mode. I know for sure there is not a P/L decoder in the repeater. Any ideas? txctcssdefault=100.0 ; default tx ctcss freq, any frequency permitted rxctcssfreqs=100.0 ; rx ctcss freqs in floating point. must be in table txctcssfreqs=100.0 ; tx ctcss freqs, any frequency permitted carrierfrom=usb ; no,usb,usbinvert,dsp,vox ctcssfrom=no ; no,usb,dsp rxdemod=speaker ; input type from radio: no,speaker,flat -- Tim, WD6AWP :wq
Tim Sawyer wrote:
I am attempting to get carrier squelch mode to work. The relevant parts of my usbradio.conf are shown below. Even with this configuration the repeater is always in P/L decode mode. I know for sure there is not a P/L decoder in the repeater. Any ideas?
txctcssdefault=100.0 ; default tx ctcss freq, any frequency permitted rxctcssfreqs=100.0 ; rx ctcss freqs in floating point. must be in table txctcssfreqs=100.0 ; tx ctcss freqs, any frequency permitted carrierfrom=usb ; no,usb,usbinvert,dsp,vox ctcssfrom=no ; no,usb,dsp rxdemod=speaker ; input type from radio: no,speaker,flat
-- Tim, WD6AWP :wq
_______________________________________________ App_rpt-users mailing list App_rpt-users@qrvc.com http://qrvc.com/mailman/listinfo/app_rpt-users
Yes, there's an annoying issue with CTCSS which needs to be fixed. Comment out the rxctcssfreqs and txctcssfreqs entries and it should start working. This issue logged in Mantis. Steve WA6ZFT
participants (2)
-
Stephen Rodgers -
Tim Sawyer