On 1/25/16 8:26 PM, Jerry DeLong wrote:
Bryan what did you have in mind for a router/switch?
Ideally I'd like to get something like a cisco 2821 and/or managed switch. The general plan is based on the following hardware: UBNT 3.4 GHz bounce link for back haul to 8th floor Ubiquiti 5G-19-120 Sector antenna, 120 degree, 19 dBi, horizontal WaveGuard AM5G19 RF shielding for sector antenna MikroTik RouterBOARD RB912UAG-5HPnD 5 GHz MIMO modem RF Elements SBX-S-CC-2SMA shielded outdoor radio enclosure Ubiquiti TOUGHCable Pro & grounding connectors Lightning Protector for cat5 I have the cable/connectors/lightning protector and the 3.4 GHz link radios. I'd like to the repeaters online first as I have most of what is needed for that. I ordered 300' of 7/8" hardline and connectors for 2$ per foot. This is new on the reel, so it's what we need for 900/440/220. I have the snap in hangers and grounding kits for the hardline, and am getting 3' treated 4x4's for the horizontal runs across the roof. We'll need a ground bar for up at the upper roof and polyphasers for the individual cables. I've had the 220 repeater testing key down for about 12 hours now and it has most of the bugs worked out of it, it will never be as good as a commercial unit however. I need to make up some interconnect cables for between the duplexer and filters and repeater. I need to reload the software on the controller linux pc, but I could do that remotely if needed. James is working on the licensing for the building stuff, and we have confirmed a repeater will work for them. I have a UPS that needs new batteries but it should work, and has the management card in it too. I tested the serial server and it's working to manage the quantar repeaters remotely too. Next time I go by we'll stop by sams club and get a folding table and chairs so we have some work space for up there. 73's -- Bryan Fields, W9CR Florida Simulcast Group, Inc.