On 1/2/17 8:30 AM, Edward Erny wrote:
[admin@MikroTik] > /interface wireless [admin@MikroTik] /interface wireless> set [ find default-name=wlan1 ] band=5ghz-onlyn channel-width=10m hz disabled=no \ \... frequency=5180 frequency-mode=superchannel ht-rxchains=0,1 ht-txchains=0,1 \ expected end of command (line 2 column 44) [admin@MikroTik] /interface wireless> l2mtu=2290 mode=station-bridge radio-name=$NZ1Q-StPete scan-list= HamWAN ssid=HamWAN \ syntax error (line 1 column 6) [admin@MikroTik] /interface wireless> wireless-protocol=nv2 syntax error (line 1 column 18)
Try putting this all on one line. It should work. Take the '$' out of radio-name, just make it NZ1Q-StPete /interface wireless set [ find default-name=wlan1 ] band=5ghz-onlyn channel-width=10mhz disabled=no frequency=5180 frequency-mode=superchannel ht-rxchains=0,1 ht-txchains=0,1 l2mtu=2290 mode=station-bridge radio-name=NZ1Q-StPete scan-list=HamWAN ssid=HamWAN wireless-protocol=nv2
[admin@MikroTik] /interface wireless> /interface vlan [admin@MikroTik] /interface vlan> add interface=wlan1 l2mtu=2286 name=MGMT-20 vlan-id=20
Not sure why this didn't work. take out the l2mtu command and try it. Mikrotik loves to change up their cli between platforms without documenting it. /interface vlan add interface=wlan1 name=MGMT-20 vlan-id=20
expected end of command (line 1 column 21) [admin@MikroTik] /ip dhcp-client> add default-route-distance=0 dhcp-options=hostname,clientid disabled= no interface=MGMT-20 input does not match any value of interface
This is cuz of the first vlan issue. Add it after you fix the 20 vlan.
[admin@MikroTik] /system identity> set name=$NZ1Q failure: empty identity string
Take the '$' out of it, just make it NZ1Q-StPete BTW, you're 5 miles from St Pete, and 11 miles from Tampa. The Tampa shot is basically all over water, so try both and see what is better 73's -- Bryan Fields, W9CR Florida Simulcast Group, Inc.