[App_rpt-users] Remote commands

[Neal Garbenis]

Lu

Yes I did have a typo sorry. Once you have control everything should work.  

Neal

Sent from my iPhone

On Jul 27, 2011, at 9:15 PM, "Lu Vencl" <vencl at att.net> wrote:

> Neal, I think you have a typo below.. Should it not be *4XXXXXX?
> 
> That is what I have to do to get the remote command back.. Once I have control, I tried *3xxxxx to connect a node , or even *81 to force time announce, but neither work.
> 
> So I presume there is a permissions issue or something else I am doing wrong?
> 
>  
> 
> From: Neal Garbenis [mailto:njgarbenis at gmail.com] 
> Sent: Wednesday, July 27, 2011 9:08 PM
> To: Lu Vencl
> Cc: <app_rpt-users at ohnosec.org>
> Subject: Re: [App_rpt-users] Remote commands
> 
>  
> 
> Lu
> 
>  
> 
> I am no expert but I do use the remote command often. First you need to be connected to the node that you want to control. Then dial *xxxxxx (the node you want to control).  You will then hear a very overdriven audio file that says remote command.   From that point on you are controlling that node you can (connect,disconnect, etc). To exit remote comand mode hit the # sign. 
> 
>  
> 
> Hope this helps
> 
> Neal
> 
> NG8Y
> 
> 
> Sent from my iPhone
> 
> 
> On Jul 27, 2011, at 8:52 PM, "Lu Vencl" <vencl at att.net> wrote:
> 
> Ok,
> 
> I know this is a newbie question, but I searched everywhere I know and I can’t find an example nor figure this out..
> 
> I need to understand the proper command structure or procedure of *4 remote command.
> 
> Example, I want to issue a command to one of my nodes from another node. How do I do this?
> 
>  
> 
> I tried the following example from my node 27870
> 
> KA4EPS-R-Margate*CLI> rpt fun 27870 *427869*81#
> 
>  
> 
> I thought that this command would allow me to announce the time on node 27869 while entering this on the 27870 node..
> 
> Is this not possible?
> 
>  
> 
> Another example, let’s say I want 27869 to connect to 27875 would I want to dial over the air on (node 27870)  *427869*327875#  ?
> 
> Thanks again for your help.. I am just not getting anywhere with it.
> 
> Lu, KA4EPS
> 
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20110727/0b676405/attachment.html>