[App_rpt-users] Static IP Setup

Fri Oct 11 18:28:12 UTC 2013

I always just edit /etc/network/interfaces rather than using any built in
utilities. It's especially helpful if you use different distributions
across multiple platforms as it's all uniform.

No need to learn/use each distro's own utility, plus you can do exactly
what you want instead of being limited by what the utility will let you do
or will do without you knowing.

Like most things in Linux there is usually more than one way to do things
and it comes down to personal preference.

Brett KQ9N
On Oct 11, 2013 10:24 AM, "Johnny Keeker" <cypresstower at yahoo.com> wrote:

> there are two ways as [root@~]
> system-config-network
> setup
>
> upon change your settings, restart your network service, or reboot if you
> like
>
> ifconfig eth0 down
> ifconfig eth0 up
>
> (note) for those installing ACID for the first time, It's best to use DHCP
>
> Comments or Corrections are kindly accepted
> JK
>
>   *From:* VA3RZS <va3rzs at gmail.com>
> *To:* Johnny Keeker <cypresstower at yahoo.com>
> *Sent:* Thursday, October 10, 2013 9:16 PM
> *Subject:* Re: [App_rpt-users] App_rpt-users Digest, Vol 56, Issue 20
>
>  What's the command to set the IP address
>
> I have googled it and find 30 different ways
>
> With red hat it was netconfig
>
> But that command does not work in centos
>
> Richard Szajkowski
> CMRK.NETworks
> (705)536-0769
>
> On Oct 10, 2013, at 8:31 PM, Johnny Keeker <cypresstower at yahoo.com> wrote:
>
>   At the least you have success.  It takes about 10 minutes or less, when
> you first boot
> before your node reports to all the other on-line nodes. Some of my nodes
> use a static IP and others DHCP with reserved address.  Let us all know
> how things
> work out for you.
> Good luck Richard
> JK
>
>   *From:* Richard Szajkowski <va3rzs at gmail.com>
> *To:* Johnny Keeker <cypresstower at yahoo.com>
> *Sent:* Thursday, October 10, 2013 7:02 PM
> *Subject:* Re: [App_rpt-users] App_rpt-users Digest, Vol 56, Issue 20
>
>  I now have what I think is a working system ,
>
> For some reason it fails if I put in a static IP , but if I run with DHCPit finds the mic and runs
>
> If I tell it to pull down the info from the server for he node it dies
>
> I need it on a static IP for port fowarding , just like my other VoIPsystems
>
> And I did do the info on the web portal to the best I can, I entered in
> all the info it requested
>
> I even got to install your device now , this will be here Tuesday because
> of our long weekend
>
> Thanks for all the help
>
> Richard Szajkowski
>
>
> On Oct 10, 2013, at 6:31 PM, Johnny Keeker <cypresstower at yahoo.com> wrote:
>
>   did you Not Create an installation disk????
>  I thought you were past that point and sitting at the test prompt
> If you completed the ACID install and got the test prompt
> the password is 'setup'
> once your in root type passwd and change it
> nodesetup.sh   will run the script to push your node config files from
> the allstar server to
> your node "provided you created and saved the files prior to your ACID
> installation"
> JK
>
>
>
>   *From:* "zeppelin.1 at netzero.com" <zeppelin.1 at netzero.com>
> *To:* app_rpt-users at ohnosec.org
> *Sent:* Thursday, October 10, 2013 5:20 PM
> *Subject:* Re: [App_rpt-users] App_rpt-users Digest, Vol 56, Issue 20
>
>  Hello Richard and welcome to the Linux world;
>                                                                   You
> "must" do a CD BURN to the ISO for it to work properly, low speed is best
> for older CD ROM.
> 73 Anton/ KC2RQR
> Node 29103
>
> ---------- Original Message ----------
> From: app_rpt-users-request at ohnosec.org
> To: app_rpt-users at ohnosec.org
> Subject: App_rpt-users Digest, Vol 56, Issue 20
> Date: Thu, 10 Oct 2013 12:00:01 -0400
>
> Send App_rpt-users mailing list submissions to
> app_rpt-users at ohnosec.org
>
> To subscribe or unsubscribe via the World Wide Web, visit
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
> or, via email, send a message with subject or body 'help' to
> app_rpt-users-request at ohnosec.org
>
> You can reach the person managing the list at
> app_rpt-users-owner at ohnosec.org
>
> When replying, please edit your Subject line so it is more specific
> than "Re: Contents of App_rpt-users digest..."
>
>
> Today's Topics:
>
>   1. Help with new install (Richard Szajkowski)
>
>
> ----------------------------------------------------------------------
>
> Message: 1
> Date: Wed, 9 Oct 2013 18:14:55 -0400
> From: Richard Szajkowski <va3rzs at gmail.com>
> To: "app_rpt-users at ohnosec.org" <app_rpt-users at ohnosec.org>
> Subject: [App_rpt-users] Help with new install
> Message-ID: <B2A7C8C9-28C3-4A33-8F56-558F97D69D7D at gmail.com>
> Content-Type: text/plain; charset=us-ascii
>
> Hello to the group
>
> I am trying to get the computer on line while my interface is shipped
>
> I downloaded the ISO off the website , followed the prompts , I am not at
> a prompt
> Test >
>
> I did not enter a root password as I was not asked
>
> I can't find a PDF or anything on 1st time installs
>
> Any help would be great
>
> Thanks
>
> Richard Szajkowski va3rzs
>
>
>
> ------------------------------
>
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>
>
> End of App_rpt-users Digest, Vol 56, Issue 20
> *********************************************
> ____________________________________________________________
> NetZero now offers 4G mobile broadband. Sign up now.<http://www.netzero.net/?refcd=NZINTISP0512T4GOUT1>
>
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>
>
>  _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>
>
>
>
>
>
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20131011/060a20d7/attachment.html>