[App_rpt-users] Need a clarification -- please

[mike at midnighteng.com]

Larry,

Yes for the most part...

*2 29283  -con mon
*3 29283  -con tx-rx

*3 alone will do nothing

*1 29283  -disconnect only 29283
*1        -alone will do nothing
*71       -will disconnect every node connected to you mon or tx

Command is the same live or macro.

You do not need to disconnect (*71 or *1xxxxx) from monitor to switch
the same node to tx. 

Just issue the *3xxxxx


...mike/kb8jnm


> -------- Original Message --------
> Subject: [App_rpt-users] Need a clarification -- please
> From: larry <larry at n7fm.com>
> Date: Fri, December 26, 2014 2:52 am
> To: app_rpt-users at ohnosec.org
> 
> 
> Going to create some macros but need to understand this sequence before 
> hand.
> 
> I want to create a macro that connects a node to another node/hub in the 
> (*2 monitor only) mode.
> 
> Later if I wish to change that same connection to a (*3 transceive) mode.
> Would a macro need to first issue a *1 disconnect and then reconnect 
> with a *3 function or can you just issue the *3 command and toggle 
> directly from monitor to transceive?
> 
> I assume whatever sequence works in one direction would hold true if 
> going in reverse from tranceive to monitor only.
> 
> Thanks
> Larry - N7FM
> 
> 
> 
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
> 
> To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
> You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.