[App_rpt-users] RXDELAY in XIPAR

Lu Vencl vencl at att.net
Mon Sep 22 14:07:48 UTC 2014


Just made it long to test. But not effective. Probably only need 150 ms.  

Lu Vencl

> On Sep 22, 2014, at 9:46 AM, Tim Sawyer <tim.sawyer at mac.com> wrote:
> 
> Really? You need a 3 second delay? 
> --
> Tim WD6AWP
> 
>> On Sep 22, 2014, at 5:13 AM, Lu Vencl <vencl at att.net> wrote:
>> 
>> I have a XIPAR node that needs a little support with pulseback removal. Never had to utilize this before, but when looking in URD.conf, I don’t see the rxdelay= parameter like I do on ACID builds. I went ahead and inserted the command into the file, but there does not seem to be any action.
>> Can someone confirm the parameter and placement?
>> Here is my example:
>> [usb]
>>  
>> hdwtype=0           ; 0=std,1=dev
>> eeprom=0            ; unless you have a cable w/eeprom
>> duplex=0            ; 0=simplex, 1=duplex
>> invertptt=0
>> ;minsigproc=0        ; minimal signal processing
>> ;sendvoter=0        ; 0=default, no voter rssi, 1=enable voter rssi
>>  
>> carrierfrom=usbinvert     ; no,usb,usbinvert,dsp,vox
>> ctcssfrom=no        ; no,usb,dsp
>> rxondelay=3000              ; Gets rid of the pulseback problem
>> ;rxboost=1           ; rx input boost of 20dB
>> rxboost=0            ; no boost
>> rxdemod=flat        ; no,speaker,flat
>> txprelim=0          ; 1 = pre-emphasize and limit
>>  
>> txmixa=voice        ; no,voice,tone,composite
>> txmixb=tone         ; no,voice,tone,composite,auxvoice
>>  
>> ;txctcssdefault=77.0
>> ;rxctcssfreqs=77.0;
>> ;txctcssfreqs=77.0;
>> txtoctype=notone;  
>>  
>> rxsquelchdelay=900    ; delayline in ms carrier squelch tail eliminator
>> rxnoisefiltype=0    ; 0 for +/-5KHz, 2 for +/-2.5KHz systems
>>  
>>  
>> Lu,
>> KA4EPS
>> _______________________________________________
>> App_rpt-users mailing list
>> App_rpt-users at ohnosec.org
>> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>> 
>> To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
>> You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem. 
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.keekles.org/pipermail/app_rpt-users/attachments/20140922/20917ad4/attachment.html>


More information about the App_rpt-users mailing list