[App_rpt-users] RTCM Inbound (Eth Rx) packet out of bounds

[Jesse Lloyd]

I've use just an unmanaged switch, which would fail to 10 half. 

A fully managed one that you can force your duplex setting on would probably work fine. 

Cheers,
Jesse

> On Nov 29, 2017, at 4:53 PM, Bryan Fields <Bryan at bryanfields.net> wrote:
> 
>> On 11/29/17 7:07 PM, Jesse Lloyd wrote:
>> I suspect that if you get a packet collision using the 10 Mbps 1/2 duplex then
>> the delayed packet used for timing breaks things... this is a guess at this point.
> 
> What kinda of switch do you have this connected to?  A proper switch should
> eliminate any collisions.  I have an EX everything plugs into, and you will
> need to set the RTCM to full duplex and manually configure the switch to
> 10/full.  The RTCM doesn't do auto negotiation, and the switch will default to
> 10/half if it fails (this is the 802.3 standard)
> 
> 73's
> -- 
> Bryan Fields
> 
> 727-409-1194 - Voice
> http://bryanfields.net
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at lists.allstarlink.org
> http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users
> 
> To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
> You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.