Hi Keith I have used an Icom F420 very successfully on Allstar for some time The F510 is basically the same Radio The pin 6 Horn drive output is the Carrier Detect (COR) line, Use the Mod in line for the Tx audio and the Det AF out for the RX audio you will also need to jumper a solder pad inside the Radio to enable the TX audio form the Mod in line to the modulator in the Radio All the best 73's Bob VK6ZGN _____ From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of keith Sent: Saturday, 2 November 2013 1:11 To: app_rpt-users@ohnosec.org Subject: [App_rpt-users] Icom F510 Evening all, I have 5 x Icom F510 radio's and would be interested in getting this radio on my All-Star node. Has any station used this make and model on an All-Star node please. I have purchased the 9 pin data feed but was not able to locate a COR line the following details is the pin assignments from this data port as listed below. 1. Do I need a COR / COS line or will the detail below be enough to install this PMR radio as my All-Star node? If at all possible an idea of the rpt.cfg to accommodate such a radio please? The data out and in on this radio shows 1200 Baud. Kind Regards Keith Handscombe G7DNT _____ No virus found in this message. Checked by AVG - www.avg.com Version: 2014.0.4158 / Virus Database: 3615/6782 - Release Date: 10/25/13
