I run quite a few Limey nodes. I have had this happen and it seems if you wait 10-20 minutes it starts working. I think the node has to register first. Also make sure the last thing that shows up on the monitor is ztttanscode loaded. It will not work until you see that. Lee 2233 In a message dated 7/14/2013 6:48:37 A.M. Pacific Daylight Time, jrh@g0fhm.co.uk writes: On 14/07/2013 13:15, James Hill wrot
Hi Jim,
Righto - it's a case of old habits die hard.... I've always used chan_usbradio on more powerful hardware. I'll reinstall Limey on another CF card, and this time set up for simpleusb.
Cheers,
James
Hi Guys, I give up! No matter what I do, Limey seems to think that my CM108 device is "Not active". If I run lsusb it shows as there. Running simpleusb-tune-menu it shows it as there and selectable, but when I try to change a parameter it just says it's not active. I tried a fresh install on a different CF card for simpleusb. Same thing! If I plug a 2.5" HDD into the thin client running ACiD, everything works fine! I'm confused! J 29681 _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users