Have you tried increasing the squelch level? What is the current squelch level? Corey N3FE From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Bill Hurlock Sent: Thursday, October 03, 2013 7:46 PM To: app_rpt-users@ohnosec.org Subject: [App_rpt-users] Long Squelch tail problem I had to go back to my URI interface and my FT-736R. I have it set up to do tone encode and decode using the URI. All the encode and decode are working however when I unkey there is a squelch tail that lasts about 1 to 2 seconds. I'm allowing the URI to determine COR thru DSP. The connections are setup for raw audio both ways with the node supplying the pre and de emphasis. I have played with the settings but nothing changes the problem. It isn't a consistent duration of tail. I know it is in tone decode mode because if I turn tone off on the portable I can't open the squelch thru the node. Anyone have any ideas...... Bill Hurlock CPCommunications 856-234-1661 Office 856-264-1010<http://www.totalrf.com/> Cell www.cpcomms.com<http://www.cpcomms.com/> WA2TQI -- This message was scanned and is believed to be clean. Click here to report this message as spam.<http://simba.repeater.net:8080/cgi-bin/learn-msg.cgi?id=33F0DD0244.A818B>