Thanks for the file path for the examples that helped a lot. Got my APRS question fix by that! I did locate the rpt.conf file in /etc/asterisk but it did not have the line "duplex = 2" in it. So I went ahead and added duplex = 0 in the file. Funny it wasn't in the file to begin with. I did locate the issue after all this. The adapter I purchased had a wire reversed in the plug. Rewired the RJ-45 and now it works! Thanks for the information! Wade KC0MLT On 11/10/2013 10:46 AM, Doug Crompton wrote:
Wade,
You mentioned you set all duplex=0 then you said you were not able to find the rpt.conf file. There is a duplex= in that file in the node section that needs to be set to either 0 - simplex, no telementry or courtesy tones or 1 - simplex, with telemeter and courtesy tones. If this is not set to simplex and you are using a single transceiver the COS/COR or carrier/signal detect will key the PTT and you will have a race condition. The default is duplex=2 which is the commonly used value for repeaters.
rpt.conf is (should be) in the /etc/asterisk directory. If for some reason it is not there look for a sample rpt.conf in /usr/src/astsrc/asterisk/configs/
I am not sure what percentage of users configure as repeaters vs. simplex nodes but maybe it would be a good idea to default this value to 0 or 1 as so many including myself get burnt by this. Also there should be a sentence about this in the quick install instructions.
*73 Doug WA3DSP http://www.crompton.com/hamradio*
From: asylthe@kc9ona.com Date: Sun, 10 Nov 2013 08:38:22 -0600 To: wadeo@charter.net CC: app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] Radio TX / RX oscillation and APRS questions
carrierfrom=usbinvert
Sent from my iPhone
On Nov 10, 2013, at 1:24 AM, wade <wadeo@charter.net> wrote:
Good evening all,
I have a couple of questions here. I just setup my AllStar node today. After hours digging through the sites and getting the files setup correctly I have ran into a problem I can not figure out. My radio that is hooked up to my AllStar adapter keeps oscillating between TX & RX non stop. I have set every instance of duplex I could find to Duplex=0. I have also set carrierfrom=usb. This radio is a Radius UHF Mobile. I have double checked the wiring connections and all is good.
I am having difficulty in finding just where the rpt.conf file I am to be modifying actually is. The usbradio.conf file I changed was located at /etc/asterisk/usbradio.conf.
My second question is where is the APRS file located at? I have seen instructions and they have all said /etc/asterisk/gps.conf. is the location. When I look there it is missing. Has something changed that moved the file elsewhere?
I am kind of new to this whole linux thing and may need a little extra assistance in getting to where I need to be. So far it has been fairly easy with the limited linux background that I have.
I hope I have given enough information to help figure this all out.
Thanks!
Wade Oestreich KC0MLT _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users