Hi Mike, thanks for the reply. Right now the carrierfrom is set to DSP. I am not sure if that is correct or not. The radio (Maxon sm2544 data radio) I am using has audio noise all the time at the input when no signal is there and my audio when key my handheld and talk to it. I will check the tone issue as I believe I tried a couple of different selections and yes it did set the tone to 100 at allstar. I don’t need tone I believe as the transmitter generates it. On the receive end it is listening to a repeater that is also generating tone back if I want it. I tried changing the rxtone to that tone the repeater had as well and nothing. I will check the carrier issue and tones again though. Oh, I did unplug the URI and plug it back in as well. Even went so far as to reinstall ACID all over again. My configuration is for a remote base transmitting to a repeater so we can offer a alstar link to it if that gives anyone an idea. Thanks Steve N4YZA From: mike@midnighteng.com Sent: Friday, May 17, 2013 9:48 AM To: app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] A problem I am having I'm sure you will get a few reply's but just on the surface I would ask is -Do you have CTCSS set a tone as opposed to NO ? rxctcssfreqs=no I think by default the acid install sets it to 100.0 ? but i'm not sure. Also in usbradio.conf Make sure your input logic is correct (don't use mine but here are some options) carrierfrom = ;carrierfrom=no ;carrierfrom=dsp ;carrierfrom=pp carrierfrom=ppinvert ;carrierfrom=usb ;carrierfrom=usbinvert ;carrierfrom=vox ctcssfrom=dsp Your usb dongle may be stuck. remove it for a second and plug it back in same place. Make sure it assigns the same position as you have described. I have a few that get stuck and replaced them. not sure why but it does happen. ...mike/kb8jnm 29283 -------- Original Message -------- Subject: [App_rpt-users] A problem I am having From: "The Rices" <srice3@cfl.rr.com> Date: Fri, May 17, 2013 8:45 am To: <app_rpt-users@ohnosec.org> I am brand new to this and have been reading to see if I can find a solution to the problem I am having. I purchased a URI and installed it with no problems. I set up the computer using acid and it accepted the node and server info and seems to come on line fine. When I connect using allstar it connects to the radio and announces it I am connected. When I use the computer microphone I can hear it come out on the radio fine. BUT when I go to listen there is no audio coming back over the link from the radio. I checked with a scope to be sure I had audio and I do. I ran the radio adjustments for rxnoise and rx voice and it said everything was successful. It did have me adjust the squelch higher though. I made sure to open the 2 ports ssh and the udp so I don’t think it is a port issue on the router. I am sure it is something simple but I am not sure where to look next. Any helpful suggestions for a beginner would be appreciated. Thanks Steve ------------------------------------------------------------------------------ _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users -------------------------------------------------------------------------------- _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users -------------------------------------------------------------------------------- No virus found in this message. Checked by AVG - www.avg.com Version: 2013.0.3336 / Virus Database: 3162/6331 - Release Date: 05/17/13