Hi, I have a Garmin GPS connected to my RTCM. The RTCM is spitting out the following error message which I cannot locate info about. "06/13/2013 05:05:24.980 Warning: GPS Data time period elapsed" Here is the config & status if that helps. 1 - Serial # (1137) (which is MAC ADDR 00:04:A3:00:04:71) 2 - VOTER Server Address (FQDN) (removed) 3 - VOTER Server Port (667), 4 - Local Port (Override) (0) 5 - Client Password (removed), 6 - Host Password (BLAH) 7 - Tx Buffer Length (3000) 8 - GPS Data Protocol (0=NMEA, 1=TSIP) (0) 9 - GPS Serial Polarity (0=Non-Inverted, 1=Inverted) (0) 10 - GPS PPS Polarity (0=Non-Inverted, 1=Inverted, 2=NONE) (0) 11 - GPS Baud Rate (4800) 12 - External CTCSS (0=Ignore, 1=Non-Inverted, 2=Inverted) (2) 13 - COR Type (0=Normal, 1=IGNORE COR, 2=No Receiver) (1) 14 - Debug Level (0) 15 - Alt. VOTER Server Address (FQDN) () 16 - Alt. VOTER Server Port (Override) (0) 97 - RX Level, 98 - Status, 99 - Save Values to EEPROM i - IP Parameters menu, o - Offline Mode Parameters menu q - Disconnect Remote Console Session, r - reboot system, d - diagnostics Enter Selection (1-27,97-99,r,q,d) : 06/13/2013 05:05:23.000 Warning: GPS Data time period elapsed 06/13/2013 05:05:24.980 Warning: GPS Data time period elapsed 9806/13/2013 05:05:26.980 Warning: GPS Data time period elapsed S/W Version: 1.05 03/09/2012 IP Address: 5.0.3.5 Netmask: 255.255.255.0 Gateway: 5.0.3.1 Primary DNS: 8.8.8.8 Secondary DNS: 8.8.4.4 DHCP: 1 VOTER Server IP: 67.214.190.98 VOTER Server UDP Port: 667 OUR UDP Port: 667 GPS Lock: 1 Connected: 1 COR: 1 EXT CTCSS IN: 1 PTT: 0 RSSI: 0 Current Samples / Sec.: 8000 Current Peak Audio Level: 65288 Squelch Noise Gain Value: 43, Diode Cal. Value: 40, SQL pot 239 Current Time: Thu Jun 13, 2013 05:05:27.180 Thanks, Randy W3RWN