Try core set verbose 10 for starters. Might help. certainly for DTMF. Not sure about CTCSS. Steve From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Lu Vencl Sent: Friday, July 22, 2011 9:49 AM To: 'David KE6UPI' Cc: app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] My first node attempt today Hi David, This is long fixed now.. Had an error in the USB.conf file, but what I was looking for was some sort of feedback showing DTMF detection, for which I now know I can see from CLI and perhaps a greater verbose value (I use 9) What would be nice though is COR status, for which I don't think there is any visual available that I know of.. But then again, I am using DSP now so it really does not matter. 73, Lu KA4EPS From: shawpbx@gmail.com<mailto:shawpbx@gmail.com> [mailto:shawpbx@gmail.com]<mailto:[mailto:shawpbx@gmail.com]> On Behalf Of David KE6UPI Sent: Friday, July 22, 2011 9:28 AM To: Lu Vencl Cc: app_rpt-users@ohnosec.org<mailto:app_rpt-users@ohnosec.org> Subject: Re: [App_rpt-users] My first node attempt today Hey Lu, What command are you trying to use? I don't remember a command to show CTCSS or DTMF. I guess the questions is what are you trying to do? David On Sat, Jul 9, 2011 at 7:21 AM, Lu Vencl <vencl@att.net<mailto:vencl@att.net>> wrote: Folks, Got the first one up, but I can't seem to get any command to work (unless I use CLI). Is there a script or method where I can get visual screen stats that shows CTCCS, DTMF decode etc? Similar to IRLP's read input? Thanks Lu KA4EPS _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org<mailto:App_rpt-users@ohnosec.org> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users