Hello Jon, I did try what you mentioned and was able to get the repeater to key up on two different PL tones. However, both tones did key up the link. I matched all parameters in the usbradio.conf file and restarted. Any ideas? boB W5EVH On Nov 6, 2013 6:57 AM, "Jon Rorke" <jrorke@cogeco.ca> wrote:
Yes App_Rpt does support multi tone. I have done it.
If you use the defined default tone then your signal goes out over the repeater and any links connected.
If you use one of the alternate tones defined then only the repeater works locally and your signal doesnt not go out on any connected links.
[usbNODE#]
hdwtype=0 rxboost=1 txboost=1 rxctcssrelax=1 txctcssdefault=103.5 rxctcssfreqs=103.5,136.5,156.7 txctcssfreqs=103.5,136.5,156.7 ;rxctcssoverride=0 ;carrierfrom=usbinvert carrierfrom=dsp ;ctcssfrom=no ctcssfrom=dsp rxdemod=flat txprelim=yes txlimonly=no txtoctype=phase txmixa=composite txmixb=no invertptt=0 duplex=1 rxondelay=0 rxnoisefiltype=0 eeprom=0
#includeifexists custom/usbradio.conf
From the above example from usbradio.conf you can see that the default tone is 103.5 but it will aslo work on 136.5 and 156.7.
But if you use the non default tones it only works in local mode.
Jon VA3RQ
On 11/5/2013 11:02 PM, Robert A. Poff wrote:
While it won't selectively route to network or local only, you can use multiple tones.
Operating like a community repeater.
In usbradio.conf (urd.conf for XIPAR), on the rxctcssfreqs and txctcssfreqs lines put the additional tones separated by commas.
These of course need to be standard PL frequencies.
Last year we needed to transition from 123.0 to 146.2. Ran both PLs for two months.
-- Sent from my Android phone with K-9 Mail. Please excuse my brevity and typing errors.
_______________________________________________ App_rpt-users mailing listApp_rpt-users@ohnosec.orghttp://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users