Gary, See below-- On Saturday 28 October 2006 18:57, Gary Young wrote:
Thanks for the info. Confirm you must go into command mode to generate the DTMF?
Yep.
I was not using command mode (I don't really understand what it command mode is) so that could be the problem.
The purpose of Command Mode makes is to make your local node command decoder ignore any DTMF, and instead forward it over the link to the far end where it gets decoded. When you are in commend mode, you should hear an extra beep in the courtesy tone sequence on the node you are accessing. You must remember to exit Command Mode when you are finished commanding the local node. If you do not, no audio will passed in command mode.
My config is the same as yours so hopefully it is the lack of 'command mode' that was the problem. I'll try it and see what happens.
Tell me more about using the '0' feature instead of a node number.
0 is shorthand for the last valid node number entered. If you connect to node 1234 using *31234, you can go in to command mode on node 1234 by dialing *40, or disconnect from node 1234 by dialing *10.
Gary
-----Original Message----- From: app_rpt-bounces@lists.illiana.net [mailto:app_rpt-bounces@lists.illiana.net] On Behalf Of Jim Duuuude Sent: Saturday, October 28, 2006 1:47 PM To: app_rpt@lists.illiana.net Subject: Re: [App_rpt] Passing DTMF?
On my test node (102), I set the following:
duplex = 0 ; No duplex, no response (mostly) propagate_dtmf = yes ; Propigate non-function DTMF digits linktolink = yes
On my normal node (2001), I hit *3102 to bring up a full duplex link to node 102. I then go into command mode for node 102, by entering *40 (since 102 was the last addressed node). Then, whatever touchtones I hit, like 123 comes out the transmitter of node 102 just like it should.
_______________________________________________ App_rpt mailing list App_rpt@lists.illiana.net http://lists.illiana.net/mailman/listinfo/app_rpt