I've not played with this but my guess is... You in usbradio.conf you should put this in the [usb] stanza: pp2=out0 ; set parallel port pin 2 to low output. Then this should change it to high: CLI>rpt cmd 2211 cop 61 pp2=1 Jim or others please jump in here if I have it wrong. -- Tim :wq On Jan 25, 2011, at 10:35 AM, K&R Yoksh wrote:
Hi Tim, Thanks for the reply.. I've been playing around at the CLI prompt, and can get functions such as this to work: rpt cmd 2211 cop 4 0 However, I still can't seem to control my parallel port I/O pins. I've followed all of the advice on http://ohnosec.org/drupal/node/177 Any suggestions? Thanks.. 73 Kyle K0KN
--- Original Message --- You do not have to assign a dtmf.
Example: CLI> rpt cmd 2535 cop 1 0
The above command is a warm boot. 2535 is my node number. Notice the trailing 0 is needed to satisfy the command interpreter but has no meaning.
Asterisk has command line help. Type "rpt cmd" and press enter will show options.
-- Tim :wq
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users