Try numbering your memories from 00 to 99 instead of three digits. Mark Johnston <markjohnston73@gmail.com> wrote:
Hello everyone,
I have finally got the ic-706 remote base partially working I can scan freq, move up in freq, and read status, Now that the commands also the init=freq..... works when I connect so it can set the frequency. just fine, yet if I do *1444*000*0... etc does not work If I do *0001 for memory 001 etc, I get 'memory not found'
which the memory is in the rpt.conf
[memory] ;Syntax : CC=RRR.RRR,PPP.P,AAAAA ; C=Channel Number ; R=RX Frequency ; P=PL Frequency ; A=Attributes ; ;Attributes : a=AM b=LSB f=FM u=USB ; l=Low Power m=Medium Power h=High Power ; -=Minus TX Offset s=Simplex +=Plus TX Offset ; t=TX PL on r=RX PL on ; 004=147.700,123.0,fshrt 005=147.100,123.0,fshtt 006=003.860,100.0,bshrt init=003.980,100.0,bshrt ;Set to this on startup
This is just above the macro section below the functions-remote...
At the end of the file I tried[memory]
[memory] 001=147.700,123.0,fshrt 002=147.100,123.0,fshtt 003=003.860,100.0,bshrt
None of these work, always says 'memory not found'
Any ideas? I know I am getting close to making this work!
0=remote,1 ; Retrieve Memory 1=remote,2
Mark KC7DMF
------------------------------------------------------------------------
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
-- Sent from my Android phone with K-9 Mail. Please excuse my brevity and typing errors.