Via ssh command line nano /etc/network/interfaces ### Put the following in # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). source /etc/network/interfaces.d/* # The loopback network interface auto lo iface lo inet loopback # The primary network interface auto eth0 allow-hotplug eth0 iface eth0 inet static address ipaddr netmask 255.255.255.255 broadcast ipaddr gateway 192.168.1.1 dns-nameservers 8.8.8.8 ## Just to be sure gateway is working correctly add the below post-up /sbin/ip route add Gatewayip dev eth0 post-up /sbin/ip route add default via Gatewayip pre-down /sbin/ip route delete Gatewayip dev eth0 pre-down /sbin/ip route delete default via Gatewayip ## End of /etc/network/interfaces I hope the above helps you in setting your static ip on your system.. Good luck if you need anything just holler! Loren Tedford (KC9ZHV) Phone Main: 1+ (631) 686 – 8878 Option 1 Fax: 1-618-551-2755 Email: loren@lorentedford.com Email: KC9ZHV@KC9ZHV.com http://www.lorentedford.com http://www.kc9zhv.com http://forum.kc9zhv.com http://hub.kc9zhv.com http://Ltcraft.net http://voipham.com From: CHARLES BENN Sent: Monday, April 9, 2018 5:56 PM To: app_rpt-users@lists.allstarlink.org Subject: [App_rpt-users] Static IP Config I loaded the new image and did the original set up with DHCP. I log on to the Console using root enter the info using the ASL-Menu and save it but the IP remains DHCP. After hitting OK there is a quick flash of some info at the bottom of the screen but its is gone before I can read it. Any suggestions 73 Charlie WB2SNN 27904-27908