9 May
2015
9 May
'15
10:17 p.m.
I am trying to send DTMF codes to an SCOM controller via an AllStar link. I have enabled propagate_dtmf=yes on both sides, and I think the tones are reaching the remote node, but it is not been sent out on the remote end. I have seen references suggesting you this in command mode, but I want the remote node to ignore the tones, and output it to the SCOM instead, so this doesn't seem appropriate. Does anybody have a HOWTO on this? 73 Willem AC0KQ ================================================================ Dr. Willem A. Schreuder, President, Principia Mathematica Address: 445 Union Blvd, Suite 230, Lakewood, CO 80228, USA Tel: (303) 716-3573 Fax: (303) 716-3575 WWW: www.prinmath.com Email: Willem.Schreuder@prinmath.com