Actually, just turn the repeater off, then later back on. Will test this. I see I don't have it in rpt.conf. Also, how do I tell which version of DIAL I have installed? Thanks, Bob _____ From: App_rpt-users [mailto:app_rpt-users-bounces@lists.allstarlink.org] On Behalf Of Bryan D. Boyle Sent: Friday, May 26, 2017 10:03 AM To: Users of Asterisk app_rpt Subject: Re: [App_rpt-users] Temporary stop, then restart asterisk cop 2 system enable cop 3 system disable -- Bryan Sent from my iPhone 6S...No electrons were harmed in the sending of this message. On May 26, 2017, at 11:57, Mike - W5JR <w5jr.lists@gmail.com> wrote: Do want to stop AllStar/Asterisk or just turn the repeater off? There is a COP command for the latter. I'm not in front of a terminal to get you the command. tnx Mike / W5JR Alpharetta GA On May 26, 2017, at 11:46 AM, Bob Pyke <k6ecm1@gmail.com> wrote: Hmmm... sounds like an update is in order :-) Thanks much, Bob Sent from my iPhone On May 26, 2017, at 8:41 AM, Steve Zingman <szingman@msgstor.com> wrote: OK, /etc/init.d/asterisk stop <--- Stop asterisk killall -9 asterisk <---------------- Make sure it's dead ps ax | grep asterisk <--- Check to see if it's really dead /etc/init.d/asterisk start <--- start asterisk ps ax | grep asterisk <--- Check to see if it's really started The newer release candidate fixes this. 73, Steve N4IRS On 5/26/2017 11:37 AM, Bob Pyke wrote: No. It will be off for several minutes, but I want it to stop when commanded, and start on command. We are conducting an exercise. I don't know the version, and logging into the node does not say. We've been operating, pretty much since the introduction of app_rpt on the RPi Thanks Sent from my iPhone On May 26, 2017, at 8:31 AM, Steve Zingman <szingman@msgstor.com> wrote: Bob, Are you talking about "bouncing" asterisk? A stop followed by a rapid start? Which distribution and version are you running? 73, Steve N4IRS On 5/26/2017 11:28 AM, Bob Pyke wrote: I have a need to temporarily disable the repeater, then enable it. Timing is critical, so a delay is undesirable. What is the best way to accomplish this? I will be logged into the node. Thanks, Bob Sent from my iPhone _______________________________________________ App_rpt-users mailing list App_rpt-users@lists.allstarlink.org http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If y