Ok this is my first time posting on this forum and I would like to thanks everyone that has contributed to the Allstar project it has defiantly added a new dimension to the hobby. We are in the progress trying to get past the learning curve of adding two RTCMs (S/W Version: 1.11 11/04/2012) to our system we currently operate here in Houston Node 28099. I have them currently connected to Kenwood TKR-820s configured as a simple radio interface and audio seems to be ok as set per sw2-2,3 and sw2-4 procedures. I am normally used to setting the audio levels via the radio-tune-menu but I am guessing that will not work in this case as I get an error (Error parsing device parameters) on the server I have the voter.conf files on. So from what I get out of this is the only place to adjust any audio is on the TRCM and in the voter.conf file is that correct? Another question is where do I set the ctcss decode settings as I can set the CTCSS TX in voter.conf but normally the RX CTCSS would be in the usbradio.conf file if it was a URI.. I am just trying to get some pointers on setup and troubleshooting methods for the RTCM. So my main questions are Where is the decode CTCSS set at? Is there a radio-tune-menu for the TRCM? Where is the info that menu item 14 set debug level go so I can view it? More may come later thanks to all :) FYI I have gone through all the post on this reflector to find these answers and read the rtcm_manual I am just stumped for the moment Keep up the good work 73s KC5DAQ