Hi Fredric, That command list was pulled from the source app_rpt.c and the asterisks are to comment those lines out. To excute those commands you will need to create a function. I put them under [functions] in /etc/asterisk/rpt.conf. For example: [functions] 900 = cop,58 ;Tx CTCSS On Input only Enable 901 = cop,59 ;Tx CTCSS On Input only Disable A *900 will execute TX CTCSS Enable, *901 will execute TX CTCSS Disable. Also Allstarnode.com is not maintained by the developers of app_rpt, it is a third party site. The current site for configuration information is http://ohnosec.org/drupal. The variable you are looking for is documented at http://ohnosec.org/drupal/node/176. Monty On Sun, Jan 1, 2012 at 2:04 AM, Fredric Moses <fred@moses.bz> wrote:
I am working on getting a logic output to run my PL encoder for COR active PL on the main repeater port. using a variable i was able to get it to work fine with local RX audio. When a signal is present I have a gpio pin going low.. when not present going back high.. but can not find a variable to watch for IP links coming in. Is there one? Is there something I can watch so that I can make the logic pin swing..?
Some google foo found these commands * 56 - Rx CTCSS Enable * 57 - Rx CTCSS Disable * 58 - Tx CTCSS On Input only Enable * 59 - Tx CTCSS On Input only Disable http://allstarnode.com/viewtopic.php?f=5&t=8
The only mention I see of TX PL is with use of a USB radio interface. Will *58 follow the tx pl settings set in usbradio if I had a USB radio device vs using one of the LOX ports for the main repeater..
-- Fredric Moses - W8FSM - WQOG498 fred@moses.bz
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users