If you read the instructions on the support pages for creating custom voice announcements with the Audacity program, you'll see that you are instructed to set the final level of the voice file to -6 db before saving it. I assume that this is based on 5Khz deviation radios. The voice announcements are mixed with all the other levels through the sound card chip and I suspect that the only way to adjust the voice without affecting the other levels is to re -record the sound files with a lower level specifically for use with narrow band 2.5 Khz radios. Ken On Fri, Dec 10, 2010 at 7:09 AM, Ken Leisten <dacndar@gmail.com> wrote:
Yes, all radio levels were adjusted properly.
Ken ----- "Tim Sawyer" <tim.sawyer@mac.com> wrote:
From: "Tim Sawyer" <tim.sawyer@mac.com> To: "Ken Leisten" <dacndar@gmail.com> Cc: "app rpt-users" <app_rpt-users@qrvc.com> Sent: Friday, December 10, 2010 5:47:28 AM GMT -08:00 US/Canada Pacific Subject: Re: [App_rpt-users] Female voice announce levels
Did you try the transmit audio adjustment shown here?
http://app-rpt.qrvc.com/node/28
Basically you have the controller send a 1 Khz tone and adjust your tx for 3 Khz dev. The document is incorrect however... the command in default configurations is *989 (not *99). And use *989 to turn the tone off (not #)... it's a toggle
--- TIS
On Dec 8, 2010, at 12:59 PM, Ken Leisten wrote:
All,
What is the name and location of the parameter that controls female voice volume? It is too loud on my system.
Thanks,
Ken K6DND _______________________________________________ App_rpt-users mailing list App_rpt-users@qrvc.com http://qrvc.com/mailman/listinfo/app_rpt-users