Steve, Both usbradio and simpleusb are simultaneously competing for the available URI's...So, you have to train both drivers as to which URI to use. The procedure is straight-forward. This is an example for a 2 node system: 1) Fully setup the usbradio.conf and simpleusb.conf config files, each with [usb] and [usb1] stanzas. 2) Modify the rpt.conf file to use usbradio for both nodes. Stanzas like: rpt.conf: [1998] rxchannel=Radio/usb (lots of other config) [1999] rxchannel=Radio/usb1 (lots of other config) 3) Start Asterisk with "asterisk -vvvvgc" and save the usbradio_tune_xxxx.conf files: *CLI> radio active usb Active (command) USB Radio device set to [usb] *CLI> radio tune save Saved radio tuning settings to usbradio_tune_usb.conf *CLI> radio active usb1 Active (command) USB Radio device set to [usb1] *CLI> radio tune save Saved radio tuning settings to usbradio_tune_usb1.conf *CLI> stop now 4) Modify the rpt.conf setup for simpleusb: rpt.conf (test nodes 1998, 1999): [1998] rxchannel=SimpleUSB/usb (lots of other config) [1999] rxchannel=SimpleUSB/usb1 (lots of other config) 5) Start Asterisk with "asterisk -vvvvgc" and save the simpleusb_tune_xxxx.conf files: *CLI> *CLI> susb active usb *CLI> susb tune save Saved radio tuning settings to simpleusb_tune_usb.conf *CLI> susb active usb1 *CLI> susb tune save Saved radio tuning settings to simpleusb_tune_usb1.conf *CLI> stop now 6) FINALLY--You're ready! ...Change the rpt.conf to a mix/match of usbradio and/or simpleusb: rpt.conf (test nodes 1998, 1999): [1998] rxchannel=SimpleUSB/usb ;rxchannel=Radio/usb (lots of other config) (lots of other config) [1999] ;rxchannel=SimpleUSB/usb1 rxchannel=Radio/usb1 (lots of other config) 7) Start Asterisk and do further setup. 73, David KB4FXC On Sat, 21 May 2016, Steve Agee wrote:
Yes, and already "been there, done that" but the light on the second URIx stays solid.
N5ZUA