My FT897 is not reacting properly to the remote commands. Scan and step sort of work, nothing else. A mode change locks the front panel. I have the CAT Baud rate set to 9600. What am I missing here? What is the "user login" function for? Here is my config. [1022] rxchannel = Zap/1 remote=ft897 functions = functions-remote phone_functions = functions-remote ioport = /dev/ttyS0 [functions-remote] 11=remote,2 ; Set freq. 12=remote,119 ; Tune 13=remote,6 ; Set mode 21=remote,101 ; Rx PL on 22=remote,4 ; Set rx PL tone 23=remote,100 ; Rx PL off 24=remote,103 ; Tx PL on 25=remote,3 ; Set tx PL tone 26=remote,102 ; Tx PL off 31=remote,104 ; Low Power 32=remote,105 ; Medium Power 33=remote,106 ; High Power 41=remote,110 ; Bump +20 42=remote,111 ; Bump +100 43=remote,112 ; Bump +500 44=remote,107 ; Bump -20 45=remote,108 ; Bump -100 46=remote,109 ; Bump -500 71=remote,116 ; Scan + slow 72=remote,117 ; Scan + quick 73=remote,118 ; Scan + fast 74=remote,113 ; Scan - slow 75=remote,114 ; Scan - quick 76=remote,115 ; Scan - fast 61=remote,5 ; Long status query 60=remote,140 ; Short status query 99=remote,99 ; User login 0=cop,6 ; Phone PTT Gary