Running version 1.41 . Have 2 rtcms connected to mtr2000 , thunderbolt gps , pretty standard setup. My simulcast is working great, however I can't get ct decode to work properly. It's either in carrier mode or it doesn't work . Odd things happen when I put what I assume is the correct settings in the ct and for config on the rtcm. The rx light flashes and sometimes let's a signal thru , but my repeater sorta goes flaky like the rtcm is pulling the line down and flaking it out. The voltage pulsates on the CTCSS line and the repeater receiver light goes out when it is actually receiving a signal. Very odd . Is 1.41 the best version? Any ideas what I'm doing wrong?? I'm using the rdstat2 pin on the MTR for CTCSS decode and it reads 5 volts when receiving a valid pl . Thanks in advance N3FYI -- Sent from My iPad