Without knowing all the exact particulars that would be important for giving help on this, I can only suggest, setting-up a new node at remote server just for your other controller. The set-up for that is quite a bit different from normal. You have to change the duplex mode and add linktolink=yes in rpt.conf so there is no repeater tail etc. Or, depending on your exact set-up, you might be able to use regenerate dtmf on output from macros if there are a limited number of command strings you use. just some ideas, ...mike/kb8jnm
I am trying to send DTMF codes to an SCOM controller via an AllStar link. I have enabled propagate_dtmf=yes on both sides, and I think the tones are reaching the remote node, but it is not been sent out on the remote end. I have seen references suggesting you this in command mode, but I want the remote node to ignore the tones, and output it to the SCOM instead, so this doesn't seem appropriate. Does anybody have a HOWTO on this? 73 Willem AC0KQ
================================================================ Dr. Willem A. Schreuder, President, Principia Mathematica Address: 445 Union Blvd, Suite 230, Lakewood, CO 80228, USA Tel: (303) 716-3573 Fax: (303) 716-3575 WWW: www.prinmath.com Email: Willem.Schreuder@prinmath.com _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.