A good question, someone one else will have to respond, but after reloading the config file, you could force it by the command. rpt fun your_node_number *58 Keith On 5/3/13 8:58 PM, "pete M" <petem001@hotmail.com> wrote:
A start up macro is another good idea.
Just one question.. Does the startup macro run even when we do a reload from the asterisk CLI?
Envoyé de mon iPad
Le 3 May 2013 à 20:28, "Keith Goobie" <keith@goobie.org> a écrit :
What about a startup macro?
Keith
On 5/3/13 8:26 PM, "Pierre Martel" <petem001@hotmail.com> wrote:
Thanks matt,
This would work, but is there a way to make it permanent?
like in rpt.conf or such?
-----Message d'origine----- From: Matt Roberts Sent: Friday, May 03, 2013 7:56 PM To: Pierre Martel Cc: APP RPT Subject: Re: [App_rpt-users] control of the tx tone
On May 3, 2013, at 7:35 PM, Pierre Martel <petem001@hotmail.com> wrote:
All is working ok, but I have a few friend that use my repeater with some cross band repeater radio. And they have difficulty cutting in cause they have to wait after the tail and ct. before there cross band repeat radio give them the chance to tx back at the repeater.
On my old rc-210 we were able to stop encoding the ctcss tone while the courtesy tone and tail of the repeater..So they were runnign ther xband radio on tone squelch on rx and the tx on there side was fast and sharp.
Is there a way to do the same with app_rpt?
Yes! Take a look at cop commands 58 and 59.
* 58 - Tx CTCSS On Input only Enable * 59 - Tx CTCSS On Input only Disable
I have those commands defined so I can turn on and off using DTMF.
Matt Roberts n9gmr@me.com Call Sign N9GMR Allstar 28142 EchoLink 640860
_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
-- keith@goobie.org Keith Goobie Richmond Hill, ON, CANADA
-- keith@goobie.org Keith Goobie Richmond Hill, ON, CANADA