Bryan, The nodes DO have to be connected even if they're on the same LAN I've found that they have to be connected in order to pass commands from one to the other. I'm assuming yours are public nodes, mine is different because they're all private nodes except for 28257. K0JSC ________________________________ From: Ken [mailto:ke2n@cs.com] Sent: Friday, September 21, 2012 12:10 PM To: bdboyle@bdboyle.com; app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] ok... you just have to wait 15-30 minutes after restarting *either* of the systems you can avoid the wait by putting the explicit address (IP:port) in each other node's [nodes] stanza. Asterisk checks the [nodes] list before going to the registration server ... this is just like if you had some internal or non-registering nodes (numbers less than 2000, for example) except you include the port number. Ken -----Original Message----- From: Bryan D. Boyle <bdboyle@bdboyle.com> To: app_rpt mailing list <app_rpt-users@ohnosec.org> Sent: Fri, Sep 21, 2012 1:19 pm Subject: [App_rpt-users] ok... so...got it registered...and can connect between node connected on one internal server on iax port 4570 to another on iax port 4569...it shows up in the node list on the mother ship... However...using the cli command 'rpt fun node dtmf-function' between them...nada. do I have to specify somewhere the proper ports@IP (ie 192.168.1.98:4569 and vice versa) to get commands to pass between the servers? Sorry for what may seem bloody obvious... BB _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users