frequency and infrequency, amplitude and idaplitude. One is used for ID's, and the other for any other morse messages you might want to send. For instance, you might set your ID frequency at a lower pitch and volume (mine is 600 hz and 1024 amplitude), so it doesn't drown out your users, then have other morse sent at, say, 700 hz and a 4096 amplitude, say, to have a morse "K" sent as your courtesy tone. You don't have to reboot or to even restart asterisk, not in most cases anyway. I've ound that sometimes changing idrecording required an /etc/init.d/asterisk restart but mostly, not. Instead, try just reloading the repeater configuration, thus: asterisk -rx "rpt reload" Or, asterisk -r rpt reload Vy 73, -- Buddy Brannan, KB5ELV - Erie, PA Phone: (814) 860-3194 or 888-75-BUDDY On Nov 16, 2012, at 9:01 PM, "Jim W7RY" <w7ry@centurytel.net> wrote:

Also, what is the difference between idfrequency and frequency? amplitude and idamplitude?

And when I change these, I have to reboot to get them to take effect. Using rpt reload doesn't seem to make then take effect.

Thanks! 73

Jim W7RY

[morse28454]

speed=20 frequency=800 amplitude=4000 ;was 4096 idfrequency=750 idamplitude=1024

From: Jim W7RY Sent: Friday, November 16, 2012 5:37 PM To: app_rpt-users@ohnosec.org Subject: [App_rpt-users] Tone Levels

Is there a separate setting for the identifier level? What command controls it. Does this level also control the PL transmit level?

Thanks! 73 Jim W7RY

_______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users