May I get a little more insight here i realized i need to upgrade my rtcm's as well ... ... Ive been reading and studying the various reads (rtcm.pdf / voter protocol.pdf / voter system.pdf) from svn and not doing or understanding instructions properly ;\ example: I run the ENC_loader.exe ?from directory the new files are located to be used? ... And i dont see where i can enter and set target ip address of rtcm, this the .ini file? example: where am i looking for the "capture" "program" "reset" as i reboot the rtcm? Proly right under my nose but us new guys could use a tip or two. This is fairly new to me so im being a nervous newb ... please help. The only dumb Q? is the one not asked right? Tony 73 :(:) http://k5try.intuitwebsites.com/ ;(;)

Message: 4 Date: Thu, 1 Nov 2012 22:03:18 -0500 From: Chuck Henderson <rpt2@chuck.midlandsnetworking.com> To: "Jeffrey S. Carrier" <jeff.carrier@rmsmsecurity.com> Cc: app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] RTCM Firmware Message-ID: <CADEYVwhrLhozX9jzj3uzdArWDa0TZwY8wjYr6BHDaXj4FiytHw@mail.gmail.com> Content-Type: text/plain; charset="iso-8859-1"

You need the two files you will find here.

http://svn.ohnosec.org/viewvc/projects/allstar/voter/EBLEX%20C30%20Programme...

and one of the .cry files from here

http://svn.ohnosec.org/viewvc/projects/allstar/voter/board-firmware/?root=sv...

or the source files and compile your self using the microchip compiler.

The ones with SMT in the name are for the RTCM and the ones without are for the original voter board. Make sure you use the right one for the hardware that you have.

Run ENC_loader.exe and enter the Target ip address of your RTCM and click "set address" click file and select the Voter-SMT.cry file that you downloaded.

telnet to the RTCM and login Make sure that the Bootloader ip address is set to an appropriate value and saved. Issue the "r" command to reboot. Immediately click the "Capture Target" button in the Encrypted Ethernet Loader Utility. Once you see the message "LIA Status: 4000" you can click the "Program" button. Wait till you see the "finished programing file" message. Then click the "Reset LIA" button. Give it a minute and then it should be up and running the new software. I know that it works when you are on the same LAN as the RTCM. It works over a routed network if the routers properly forward UDP port 16388 and do proxy arp. I have had trouble getting it to work over the Internet via NAT at both ends. Chuck

On Thu, Nov 1, 2012 at 9:24 PM, Jeffrey S. Carrier < jeff.carrier@rmsmsecurity.com> wrote:

...

I'm noticing the F/W version on my rtcm's is 1.05 dated 3/9/2012. I think I found a much newer version but so far nothing on the procedure to update the firmware. Can it be done over the network or only locally and is there documentation on this that I've missed?

Thanks Jeff K0JSC