I did use it but now only on my one ACiD box. XIPAR has a problem currently with not being able to shut off echolink telemetry. But if that does not bother you, then we are all set. Do a core set verbose 99 and see the messages that are coming out to see if any attempt is being made.. If so, see what the failure is. -----Original Message----- From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Corey Dean Sent: Sunday, November 24, 2013 9:26 PM To: Greg; app_rpt-users@ohnosec.org Subject: Re: [App_rpt-users] XIPAR I have it loaded on 2 of my nodes and it works fine. I don't allow incoming calls though. It is just for outgoing calls. Corey N3FE -----Original Message----- From: app_rpt-users-bounces@ohnosec.org [mailto:app_rpt-users-bounces@ohnosec.org] On Behalf Of Greg Sent: Sunday, November 24, 2013 8:00 AM To: app_rpt-users@ohnosec.org Subject: [App_rpt-users] XIPAR Is it possible to use echolink with the xippar install? I see echolink.conf in /etc/asterisk but doesn't seem to activate. Thanks _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users -- This message was scanned and is believed to be clean. Click here to report this message as spam. http://simba.repeater.net/cgi-bin/learn-msg.cgi?id=4E793D0627.A974E _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users