Just made it long to test. But not effective. Probably only need 150 ms. Lu Vencl
On Sep 22, 2014, at 9:46 AM, Tim Sawyer <tim.sawyer@mac.com> wrote:
Really? You need a 3 second delay? -- Tim WD6AWP
On Sep 22, 2014, at 5:13 AM, Lu Vencl <vencl@att.net> wrote:
I have a XIPAR node that needs a little support with pulseback removal. Never had to utilize this before, but when looking in URD.conf, I don’t see the rxdelay= parameter like I do on ACID builds. I went ahead and inserted the command into the file, but there does not seem to be any action. Can someone confirm the parameter and placement? Here is my example: [usb]
hdwtype=0 ; 0=std,1=dev eeprom=0 ; unless you have a cable w/eeprom duplex=0 ; 0=simplex, 1=duplex invertptt=0 ;minsigproc=0 ; minimal signal processing ;sendvoter=0 ; 0=default, no voter rssi, 1=enable voter rssi
carrierfrom=usbinvert ; no,usb,usbinvert,dsp,vox ctcssfrom=no ; no,usb,dsp rxondelay=3000 ; Gets rid of the pulseback problem ;rxboost=1 ; rx input boost of 20dB rxboost=0 ; no boost rxdemod=flat ; no,speaker,flat txprelim=0 ; 1 = pre-emphasize and limit
txmixa=voice ; no,voice,tone,composite txmixb=tone ; no,voice,tone,composite,auxvoice
;txctcssdefault=77.0 ;rxctcssfreqs=77.0; ;txctcssfreqs=77.0; txtoctype=notone;
rxsquelchdelay=900 ; delayline in ms carrier squelch tail eliminator rxnoisefiltype=0 ; 0 for +/-5KHz, 2 for +/-2.5KHz systems
Lu, KA4EPS _______________________________________________ App_rpt-users mailing list App_rpt-users@ohnosec.org http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.