This is in the messages log after a reboot now: [Dec 26 00:06:21] WARNING[941] channel.c: Channel allocation failed: Refusing due to active shutdown[Dec 26 00:06:21] WARNING[941] chan_simpleusb.c: Unable to create new usb channel[Dec 26 00:06:21] NOTICE[944] dnsmgr.c: Managed DNS entries will be refreshed every 300 seconds.[Dec 26 00:06:21] NOTICE[944] cdr.c: CDR simple logging enabled.[Dec 26 00:06:21] NOTICE[944] loader.c: 54 modules will be loaded.[Dec 26 00:06:21] WARNING[944] acl.c: is not a valid IP[Dec 26 00:06:21] WARNING[944] chan_simpleusb.c: File simpleusb_tune_usb45467.conf not found, using default parameters.[Dec 26 00:06:21] NOTICE[961] app_rpt.c: Normal Repeater Init 45467[Dec 26 00:06:22] NOTICE[982] chan_simpleusb.c: Assigned USB device 3-2:1.0 to simpleusb channel usb45467[Dec 26 00:06:22] WARNING[982] chan_simpleusb.c: File simpleusb_tune_usb45467.conf not found, device usb45467 using default parameters.[Dec 26 00:06:22] WARNING[981] chan_simpleusb.c: Possibly stuck USB read channel. [usb45467][Dec 26 00:06:22] WARNING[981] chan_simpleusb.c: Nope, USB read channel [usb45467] wasn't stuck after all. the simpleusb_tune_usb45467.conf is present in \etc\asterisk Keith DobbinsSr. IT Systems EngineerManaged File Transfer/Mainframe Networks3402 Linden Street Parkersburg, WV 26104-1608 Amateur Radio Call Sign: N8KLD On Tuesday, December 26, 2017, 11:40:18 AM EST, Steve Zingman <szingman@msgstor.com> wrote: Which channel driver are you using? Anything in the log? 73, Steve N4IRS On 12/26/2017 11:30 AM, Keith Dobbins wrote: I had my node working under ACID till a hard drive decided to crash on me. I did the re-install with the 32 bit DIAL install. Everything about the node appears to function properly but from asterisk to my URI I get ZERO audio in or out. It's the only audio adapter, and the URIDIAG with the loopback plug tests fine. It will activate the TX and I get the blinking green led but no audio in or out. Is there somewhere I can look to troubleshoot this issue? The motherboard is an older atom 330 board. Should I fall back to the older ACID install for this node which had worked. Thanks for any guidance that you can provide. Keith Dobbins N8KLD _______________________________________________ App_rpt-users mailing list App_rpt-users@lists.allstarlink.org http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users To unsubscribe from this list please visit http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button" You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem.