Ross,
Thanks for the reply. I've had this happen to me on two different
configurations. The issue here is with the radio interface.
One is a simplex UHF application using a Motorola GM300 mobile (although
I have also experienced the same problem using GE MVS and GE MLS2).
When I receive on an Alinco DJ-596, Wouxun, GE MLS2 or another GM300, I
notice that I the first bit of audio is sometimes clipped. If I set any
of those radios for carrier squelch (as opposed to CTCSS) the problem is
less noticable. It seems to me there might be some brief delay in the
receiver decoding the CTCSS. I've looked at the transmitted CTCSS and it
is at 500 Hz modulation and a nice clean sine wave.
Where I really notice the problem is in a remote base configuation. I'm
using a GM300 VHF for this but the issue would happen with any radio.
In this application I am using the radio to access a repeater system in
the next county. That repeater, when initially keyed from idle, can
take as long as 250 mS to begin to pass audio from when it first sees
carrier and CTCSS (hey, it was free an it works so I'm not
complaining). My hope was to adjust a delay buffer here such that my
remote base would transmit but hold audio for 200 ms or so to allow the
outbound path to come alive and stabilize before putting out the audio.
It's not a big deal and is pretty much "normal" operation, but I figured
that a small delay of the audio here would clean things up a bit.
73 DE Thor
Operator of N7JCT
